Cisco Catalyst Switch 2960 Series SI POE-48 WS-C2960-48PST-L V04, Factory Reset

Cisco Catalyst Switch 2960 Series SI POE-48 WS-C2960-48PST-L V04, Factory Reset

Price : 59.99

Ends on : N/A

View on eBay
If you’re looking to perform a factory reset on your Cisco Catalyst Switch 2960 Series SI POE-48 WS-C2960-48PST-L V04, you’ve come to the right place. Follow these steps to reset your switch to its factory default settings:

1. Connect to the switch using a console cable and a terminal emulation program such as PuTTY or HyperTerminal.

2. Power on the switch and wait for the console prompt to appear.

3. Press and hold the Mode button on the front panel of the switch for at least 3 seconds. The SYST LED will start blinking green.

4. Release the Mode button and wait for the switch to reboot. This may take a few minutes.

5. Once the switch has rebooted, you will be prompted to enter the initial configuration dialog. Type “no” and press Enter to bypass this step.

6. You will then be prompted to enter privileged exec mode. Type “enable” and press Enter.

7. Enter global configuration mode by typing “configure terminal” and pressing Enter.

8. Enter the following command to erase the startup configuration:

erase startup-config

9. Confirm the command by typing “y” and pressing Enter.

10. Reload the switch by typing “reload” and pressing Enter.

Your Cisco Catalyst Switch 2960 Series SI POE-48 WS-C2960-48PST-L V04 will now be reset to its factory default settings. Remember to reconfigure the switch with your desired settings after the reset is complete.
#Cisco #Catalyst #Switch #Series #POE48 #WSC296048PSTL #V04 #Factory #Reset, Cisco Systems