Navigation GPS Antenna Replacement for Kenwood DNN990HD DNN-990HD Car Radio
Price : 12.75
Ends on : N/A
View on eBay
Are you experiencing issues with the GPS navigation on your Kenwood DNN990HD DNN-990HD car radio? It might be time to replace the navigation GPS antenna.
Replacing the navigation GPS antenna is a relatively simple and cost-effective solution to improve the performance of your car radio’s GPS navigation system. By replacing the antenna, you can ensure that your car radio accurately tracks your location and provides you with precise directions.
To replace the navigation GPS antenna on your Kenwood DNN990HD DNN-990HD car radio, you can follow these steps:
1. Turn off your car radio and disconnect it from the power source.
2. Locate the current GPS antenna on your car radio. It is typically a small, black box with a wire attached to it.
3. Carefully disconnect the wire from the GPS antenna and remove the antenna from the car radio.
4. Install the new navigation GPS antenna in the same location where the old one was located.
5. Connect the wire from the new GPS antenna to the car radio.
6. Turn on your car radio and test the GPS navigation system to ensure that it is working properly.
By following these steps, you can easily replace the navigation GPS antenna on your Kenwood DNN990HD DNN-990HD car radio and enjoy accurate and reliable GPS navigation once again.
#Navigation #GPS #Antenna #Replacement #Kenwood #DNN990HD #DNN990HD #Car #Radio,dnn
Leave a Reply